RA Studfiix V2 System For Flat Screens Up To 80kg

£345.60 + VAT



This complete installation solution is designed to enable Flat Screens or Touch Screens to be fixed to a wooden stud partition wall or solid wall and direct the weight of the screen directly to the floor.

Suitable for Clevertouch, Ctouch, Promethean ATP, Philips, Samsung, LG, Panasonic, BENQ, iTouch, Vividtouch, Hitachi, Iiyama, iBoard, Genee Screens and many more

The kit includes two upright supporting box section legs which are fixed to the existing upright wooden studs inside the wall with the Wall Mounting Plate and Floor Plate included in the kit. This creates a rigid, safe and strong fixed mounting frame for the Flat Screen Mount (included) to fix onto and position the screen at a selection of height settings. All fixings, bolts, coach screws and plastic caps are included for a neat and tidy installation.

The two Upright Supporting Legs are hollow box section design and allow connection cables to and from the screen to be routed through them. Cable exit / entry slots are positioned on the inner sides of each leg to enable surface mounted cable trunking to route cables away to a connection panel if required (not included).

Maximum CENTRE POINT of screen height from floor level approximately 1365mm.

Minimum CENTRE POINT of screen height from floor level approximately 1110mm.

Suitable for any size screen with a maximum VESA mount configuration of 800 x 600 and up to a recommended maximum weight of 80kg.

The Wall Mounting Plate can be fixed to the wall and supporting legs in either a LOWER or HIGHER position to avoid any dado rails or network trunking on the walls surface. In the LOWEST position the plate will be 915mm from floor level and in the HIGHEST position the plate will be 1250mm from floor level. The Wall Mounting Plate itself is 130mm high.


There are no reviews yet.

Be the first to review “RA Studfiix V2 System For Flat Screens Up To 80kg”

Your email address will not be published.